The coupling is attached via reverse thread. Place screwdriver atop the coupling, against the base of one of the tips, and tap briskly with a hammer in a clockwise direction (left to right). It will spin off. Install new coupling threading left to right. The blender will snug up the coupling during use. If you are in doubt, follow the
... Read more instructions of the website\\\'s video. On a scale of 1 to 10 (with 1 being the easiest) the repair is a 1.
Read less
Did you find this story helpful?
Thank you for voting!
The coupling that drove the blades had become too worn to work.
Used a screwdriver to pry off the original part, which came off in pieces, and installed the new part. I have not used it yet so hope it works as before. So glad not to have to buy a new blender. I don\'t use it often but nice to have. I ordered two couplings, and will know just what to do next time.. It seems like the coupling is the wea
... Read morekest part of the blender.
Took off the metal coupling with a screwdriver, working in a circular motion under the coupling, then cleaned off the metal pieces left, screwed on the new part and done.
I\'ve replaced this part before so I had no problems. Unplug the blender. Stick screwdriver in bottom side of blender to stop fins on shaft from turning. That stops the shaft from turning. While holding screwdriver in place put pliers on old coupling and turn clockwise. Mine came off real easy. Remember it comes off backwards from most th
... Read moreings that screw on.
1. I followed someone\'s You Tube instructions. Not the instructions that said to pry the coupling off.
2. With screwdriver, hit the coupling teeth making the coupling turn clockwise. I hit the coupling teeth three or four times and the coupling just screwed off.
3.. Screw the new coupling on.
4. Using the blender w
... Read moreill tighten it.
Read less
Did you find this story helpful?
Thank you for voting!
Kitchen aid blender stripped out and quit turning.
Happened on this website, described problem, watched a short video describing how to repair, ordered the part. Received New coupling and repaired in less than two minutes saving a couple of hundred dollars. Needless to say I have saved e replacement parts in my favorites for next time.
The \"teeth\" (???) that fit on top of the motor housing and fit up into the bottom of the jar when it\'s set on top had worn down and would no longer turn the blade inside the jar.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
