This is a Genuine Manufacturer Sourced replacement part used on Shimano Spinning Reels. This part is made out of Metal and it is Sold Individually. Ball Bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

To replace this Bearing you would need a Screwdriver

• First you would need to disconnect the Reel Handle
• Then remove the Side Cover by loosening the Screws that hold it
• You should be able to remove the old Bearing
• Install new Bearing and Reassemble the Reel

This hardware is an authentic OEM part which is designed for use with Shimano fishing reels. It helps to secure the bearing. This is an identical replacement for a damaged or a faulty hardware that was installed on a new unit. Keep in mind this high-quality E lock is made of durable metal and is sold individually. Make sure to check the appropriate diagrams of your model for the exact location and the correct installation of this component. You may need pliers to remove and replace it.

This is a Genuine Manufacturer Sourced replacement part used on Shimano Reels. It is made out of Metal and it is Sold Individually. There are Two (2) of these Screws that secure Handle Nut Plate.

Requires a Flathead Screwdriver to tighten or loosen.