This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This brush is a genuine Porter-Cable replacement part, not generic. As pictured, this brush is ready to install and includes carbon brush, wire lead, and spring. This item is sold individually. Over time, brushes will wear down and eventually require replacement.

This brush will fit the models listed in the 'Compatibility' section below. It is not guaranteed to fit any other power tool models.

• Worn brushes are often the cause of a poorly running motor
• Replacing brushes can fix an intermittent motor
• New brushes can restore a motor’s electric braking

Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

This small belt controls the random orbit functions of common Porter-Cable palm sanders. If this belt breaks, the sanders will operate poorly and the pad will rotate at a high rate of speed.
Sanding functions will be disabled.
This belt is a genuine Porter-Cable replacement part.
Removing the sanding pad and replacing this belt is an easy repair.

This belt is compatible with the Porter Cable sanders listed below.

This 5" sander pad is a genuine OEM replacement part that is specially made for Porter Cable random orbit palm sanders. It is used to secure the hook and loop PSA style sandpaper, over time this part will wear out and it will need to be replaced. Changing the pad is an easy task that will only require a screwdriver.

The 151281-08 Pad is used to hold 5 inch Hook and Loop sandpaper with 8 vacuum holes.

Over the past few years the popularity of Hook and Loop paper has grown because of the ease of changing sandpaper when needed. Over that of the PSA (Pressure Sensitive Sandpaper)

Applying too much pressure on the sander may cause premature wear on the Hook and Loop pad.
When a pad needs to be replaced, simply remove the three screws that hold the pad to the sander, then replace it with a new pad.

Genuine OEM replacement
This brush is sold individually, 2 are needed for this tool
It is always best to replace both brushes, even if only one is worn.

Worn brushes frequently are the cause behind a motor running poorly.
Replacing brushes can fix a motor that’s operating intermittently.
New brushes can restore a motor’s electric braking.

Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

There are over 120 tool that use this brush.