OEM Porter Cable Boring Machine Parts & Accessories

$6.16

Manufacturer Part Number:: 148354-03

This item is a genuine DeWalt replacement part that is intended to be used with cordless drills and drivers. The bit clip can be used as a direct replacement of the original clip that would have been installed on a new drill. The clip snaps onto the side of drill's housing and is used to store frequently used drill bits. This item is priced as a single replacement part.

BEARING

$14.92

Manufacturer Part Number:: 859293

This is a needle bearing that is open on both sides. This genuine Porter Cable replacement part is sold individually. • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduces wear on the tool, allowing it to run smoothly. • Bearin...

CORD CLAMP

$6.16

Manufacturer Part Number:: 861434

Included in part number 882350

BRUSH & RETAINER ASY

★★★★★

(1)

$16.68

Manufacturer Part Number:: 874289

Genuine Porter Cable replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore a motor's electric braking. Carbon brushes are one of t...

F/R ACTUATOR

★★★★★

(5)

$6.81

Manufacturer Part Number:: 90569693-03

BEARING MOUNT

$6.16

Minimum Quantity of 2 required

Manufacturer Part Number:: 694432

It is a genuine item that is supplied by the original equipment manufacturer for use with Porter Cable and Black and Decker equipment. This is an identical replacement for a missing or damaged bearing mount that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this hig...

Needle Bearing

$6.16

Manufacturer Part Number:: 330004-00

This item is available as an individual replacement part. The needle bearing is made of metal. A screwdriver and a set of pliers might be necessary during the installation of this item. It will require replacing if it breaks. This is a genuine Porter Cable, Black & Decker, and DeWALT part sourced directly from the manufacturer for use in drills, sanders, screwdrivers, and shears.

RET RING

$6.16

Minimum Quantity of 2 required

Manufacturer Part Number:: 859769

This is an original replacement part sourced directly from the manufacturer. The retaining ring is commonly found in power tools from Porter Cable and Delta, such as drills, shears, welders, and sanders. This part is made of metal, and is generally used to hold components inside a cylinder. It may be found in various locations in the machine, depending on model. Please refer to the parts diagr...

BRUSH & SPRING

★★★★★

(2)

$11.50

Manufacturer Part Number:: N119739

Genuine Porter Cable replacement part Includes 1 Carbon Brush with wire lead and brush spring attached. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced power tool components. • Because carbon brushes are wear it...

BRUSH HOLDER

$6.16

Manufacturer Part Number:: 865323

This is an authentic replacement part, sourced from the original manufacturer for use with electric power tools. The special brush holder is used to secure the carbon brushes. This brush holder is available as an individual replacement part, please note two brush holders are required.