Planer Jointer Parts

$33.86

Manufacturer Part Number:: 664064-4

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individually. It comes with a rubber sleeve grommet that is not sol...

Planer Drive Belt

★★★★★

(18)

$67.79

Manufacturer Part Number:: 5140010-28

This drive belt is for planers. Drive belt connects the motor pulley to the spindle assembly to spin the blades. Disconnect the power cord before installing this part. Wear work gloves to protect your hands.

BRUSH & SPRING

★★★★★

(5)

$10.36

Manufacturer Part Number:: N031635

Genuine Porter Cable replacement part includes 1 Carbon Brush with wire lead and brush spring attached. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced power tool components. • Because carbon brushes are wear ite...

Sprocket

★★★★★

(17)

$10.25

Manufacturer Part Number:: 5140010-81

Genuine Dewalt replacement part, this item is sold individually. This is a Drive Sprocket that works in conjunction with a drive chain. It is used on the Dewalt Planers shown below to drive the feed rollers. Depending on the model number you have, as in case of the DW734 uses one. The DW735 and the DW735X use four of this part.

Carbon Brush CB-124 (Set of 2)

★★★★★

(16)

$13.50

Manufacturer Part Number:: CB124

Sprocket

★★★★★

(21)

$9.56

Manufacturer Part Number:: 285928-00

Genuine Dewalt replacement part, this item is sold individually. This Sprocket is used on the Dewalt Planers listed below to drive the feed rollers There are four of these Sprockets used in each Planer. The Sprocket has eight teeth, 5/8 bore, with a 3/16 key inside the bore.

Table Saw Switch

★★★★★

(94)

$45.45

Manufacturer Part Number:: 489105-00

Carbon Brush With Spring

★★★★★

(16)

$16.10

Manufacturer Part Number:: 5140011-85

This is an authentic OEM replacement part. Sold individually. Carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Because of this, carbon brushes are one of the most commonly replaced power tool parts. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carb...

Cup Washer 12

★★★★★

(1)

$5.95

Minimum Quantity of 2 required

Manufacturer Part Number:: 253922-5

This is a genuine part sourced directly from the manufacturer. The cup washer is commonly found in Makita power tools. The washer is utilized to provide a tight fit between connected parts. It is a high-quality replacement for a damaged or a missing hardware that was installed on a new unit. Refer to the diagrams for your model to ensure the exact location and the correct application of this part....

Carbon Brush Set

★★★★★

(13)

$18.43

Manufacturer Part Number:: CB408

This #191938-1 (CB-408) Makita carbon brush set contains two individual carbon brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. This brush set will fit the Makita tools listed at the bottom of the page. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an...

Carbon Brush Set

★★★★★

(53)

$18.43

Manufacturer Part Number:: CB154

This is a genuine Makita replacement part that includes two carbon brushes with wire leads attached. Carbon brushes are essential components in power tools and are among the most commonly replaced parts due to regular wear from friction. Over time, worn brushes can cause a motor to run poorly, operate intermittently, or lose electric braking power. Replacing them can often restore your tool’s perf...

Adapter

★★★★★

(20)

$20.20

Manufacturer Part Number:: 5140011-48

Genuine Manufacturer Approved replacement part designed for certain DeWALT Planers. This part is made out of Plastic and it is Sold Individually. This Adapter allows you to connect Dust Chute to your unit.

Popular Planer Jointer Brands

Popular Planer Jointer Parts

Popular Planer Jointer Models

All Planer Jointer Brands

Shop by Popular Planer Jointer Part Types

Planer Jointer Parts

Search By Model or Part Number

Popular Planer Jointer Brands

Popular Planer Jointer Parts

Popular Planer Jointer Models

All Planer Jointer Brands

Shop by Popular Planer Jointer Part Types