Plate Joiner Parts
Search By Model Number
This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individually. It comes with a rubber sleeve grommet that is not sold separately.
Replacing this power supply cord you will need a screwdriver.
• Remove the housing screws
• Remove the the housing
• Disconnect the old cord wires
• Remove the old power cord
• Secure the new cord in place
• Connect the wires
• Reassemble and test the new cord
This cord is a genuine OEM replacement part and is sold individually. Power Cord Specifications: 2 Wires. 18 Gauge. 2 Prongs. 6-1/2 Feet Long. It is constructed with thick insulation for long service life and a strong two-prong plug. This cord is compatible with the tools listed below. It can work for other applications and for other tools as well, but compatibility is not guaranteed. Installation of this part requires the new cord wires be stripped and to fit correctly into the wire terminals.
This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.
This cord protector is a genuine DeWalt replacement part and is sold individually.
Cord Protectors are designed to slide onto your cord and fit securely at the end, where it’s firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.
Genuine OEM replacement
This brush is sold individually, 2 are needed for this tool
It is always best to replace both brushes, even if only one is worn.
Worn brushes frequently are the cause behind a motor running poorly.
Replacing brushes can fix a motor that’s operating intermittently.
New brushes can restore a motor’s electric braking.
Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.
There are over 120 tool that use this brush.
Browse Plate Joiner Parts
Plate Joiner Repair Videos
Plate Joiner Repair Articles
|How to Fix a 2-Cycle Engine Carburetor||How to Replace the Fuel Filters in Your Outdoor Power Equipment|
|This article will walk you step-by-step through the process of repairing a 2-Cycle carburetor....||This article will help you troubleshoot your fuel-line replacement repairs. ...|