This is an OEM part sourced directly from the manufacturer. The clutch cable guide is commonly found in snowblowers from Toro and Lawn Boy. This part is made of high-quality plastic, and is used to turn the clutch cable through a corner so it will connect to the idler arm from the correct angle, and also retain the correct tension. You will require a screwdriver when replacing this part. This item is sold individually.
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
A Bit Difficult
15 - 30 mins
(1 rated repair)?
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Snow paddle clutch cable broke ... the clutch cable guide became loose and broke. I believe the loose guide was the original source of the problem. I also replaced the belt
I found this fairly easy to accomplish ... It just takes a lot of words to describe the steps and pitfalls. Good luck.
Remove snow chute > 3 large screws
Finish by removing chute ring > 1 small screw
Remove 4 bolts that secure the red shroud
Remove gas cap
Remove shroud
Replace gas cap
Remove 2
... Read more screws and mounting clips holding bottom black shroud to blower handles
Remove 1 bolt > front lower right side of black shroud
Loosen shroud ... probably not necessary to remove it
Remove bolts securing belt, pulley cover
Remove cover ... lifting off tabs at bottom
TAKE A PICTURE SHOWING BELT ROUTING, PULLEYS, TENSIONING SPRING, BRACKETS ETC !!
Remove belt
>> unscrew and replaced broken clutch cable guide ... lubricate cable channel with silicon grease
>> feed replacement cable from lower back of blower into cavity ... up and around cable guide ... connect to clutch lever
>> route cable ABOVE blower handle ... connect upper end of cable to clutch handle actuator spring
>> REFER TO YOUR PICTURE
>> replace or install new belt
Replace pulley cover
Remount lower black shroud ... 2 clips & screws and 1 bolt
<><> feed the clutch cable THROUGH the left clip ... don\'t pinch it
<><> feed the 2 chute control cables through the right clip ... don\'t pinch them
Don\'t forget the bolt at the lower right front of the black shroud.
Reverse the rest of the steps!
Hope this helps =ƒÿÇ
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP16285396
Manufacturer Part Number: 140-3660
Snow Blower
- Power Clear 721 R-c Commercial Snowthrower
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
