Saw Springs and Shock Absorbers

The metal guard spring attaches to the cover set and is priced individually. It is a genuine OEM sourced part which is specially designed for use with Milwaukee circular saws. This part may become bent or broken and will need to be replaced. A set of pliers may be needed when replacing the spring.

This is an authentic replacement part manufactured for use with Delta arbor saws and table saws. The load spring is commonly used to provide spacing between the arbor bearing and the arbor flange. This load spring is available as an individual replacement part, please see model diagram for associative parts.

This replacement disc spring is an authentic OEM item that is specially designed for Milwaukee bansaws. This is one of the discs that provides a seal for the clutch. Please make sure to check appropriate diagrams for correct location and use of this hardware. This durable metal item is sold individually and it will require a torx screwdriver to complete this repair.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

Genuine Makita replacement part, this item is sold individually. The purpose of the 231806-7 Tension Spring is to raise and lower the telescoping lower guard. When you make a cut the Lower Guard will raise up inside of the upper guard, as you get to the end of your cut the Spring will cause the lower guard to return to it original position. The spring is attached to the Lower Guard and also to the...

Genuine Makita replacement part, this item is sold individually. The purpose of the 231839-2 Tension Spring is to return the Lower guard back to its original position after use. To attach the spring, one end is installed on the Lower Guard and the other end is installed in the Blade Case.

This is a Genuine OEM replacement part used on some Makita Power Tools. This is a Metal Spring and it is Sold Individually. Over time springs may loose its tension and may not function as intended. If this part is lost or damaged it must be replaced.

This is an authentic Milwaukee replacement part manufactured for use with power tools. The special compression spring is used with a variety of different types of power tools. This spring is commonly used to allow flexibility between part assemblies and to prevent jarring between the part assemblies. This compression spring is sold as an individual replacement part, please see model diagram for pa...

This compression spring is a genuine OEM replacement component designed to maintain proper tension and support smooth internal operation across a variety of power tools. Made from durable spring steel, it helps ensure consistent movement within mechanisms such as levers, guides, or trigger systems, contributing to stable performance and reliable tool function. Replacing a worn or weakened spring h...