Bostitch Nailer Springs and Shock Absorbers

This is a Genuine OEM sourced replacement part designed for use with Bostitch Staplers. This Spring connects the Pusher and the Top Guide of the Magazine. It is made out of Metal and it is Sold Individually. To replace this spring you would need pliers.

Genuine OEM replacement part, this item is sold individually. This spring is mounted to the pawl. After a nail has been fired it will close the pawl so that the next nail may be fired. This part is used by the roofing nailers listed below.

This is a genuine Bostitch replacement part. The Safety Pad is attached to end of the safety to prevent the material that it is being used on from getting marred or dented by the safety arm. It is a advisable to have one or two extra pads on hand as they do have a tendency to crack and deteriorate over time.

This is a genuine OEM sourced part that is intended to be used with pneumatic nailers and staplers from Bostitch, Porter Cable, and DeWalt. The metal spring is used to provide compression between the piston head valve and the end cap assembly. This item is sold as an individual replacement part.

The torsion spring attaches to the feed pawl. This is an authentic part from Bostitch for use in nailers. The spring is made out of metal and is priced individually. This part will need to be replaced if it becomes broken or bent. A socket set, a set of pliers, and a screwdriver may be needed during the installation process.

The return spring applies tension on the connected components of the return device. Unfortunately, over time it may wear out, get damaged or lost eventually requiring a replacement. This part is sourced from the original equipment manufacturer. It is specially designed for use with DeWALT nailers. Please make sure to refer to the diagrams for your model for the correct location and application of ...

The metal compression spring is made of metal and goes between the check pawl and the door. This part is available as an individual replacement and is an OEM replacement part from the manufacturer Bostitch for use in nailers. Springs can lose their tension over time and will need to be replaced. A set of pliers and a socket set may be needed when replacing this spring.

This is the constant force spring, also known as a pusher spring assembly, designed for use in various nailer nail-feeding mechanisms. Nailers, also known as nail guns, are essential tools for quickly and efficiently driving nails into materials, and this spring plays a critical role by attaching to the nail pusher to advance nails from the magazine to the driver. A clear sign that this spring nee...

This authentic OEM sourced replacement part is designed for use with Bostitch nailers. It provides spring action for the magazine. It is made out of metal with a plastic hub and it is sold individually. To complete this repair you would need a screwdriver.