Trimmer Vent Cover 13132840630

Removed and replaced all tubes, grommets, filters, etc., and primer bulb. Grommet was leaking for sure, bulb seems to also have had a small leak.

It all started with the purge bulb failure on the bottom of the carburetor. I replaced that first and couldn\'t draw any fuel into the bulb. I then realized that the rubber fuel line and grommet and pretty much dissolved. I disconnected the two lines connected to the carburetor. loosened the screws holding the handle and removed the fuel ... Read more tank from the Shred n Vac. I then removed all the fuel lines, filter and vent from the fuel tank and replaced all of the components. I then proceeded to reinstall the tank with the two screws tighten the handle and hook up the fuel lines to the carburetor. I replaced the spark plug and air filter element, purged some fuel to the carb and within two pulls hand it running like a charm. One note I would like to make is that I utilized a dab of grease to hold the two back washers for the fuel tank to the tank to ease re-installation of the fuel tank.