BREVILLE PRECISION BURR ASSEMB SP0110082

1. Removed hopper
2. Vacuumed out grinder assembly
3. Unlocked and removed outer grinder
4. Removed cap nut that\'s holding inner grinder, then removed inner grinder
5. Removed washers
6. Removed grind fan assembly
7. Replaced felt washer
8. Inserted grind fan assembly
9. Put replacement was ... Read more hers back in place
10. Put cap nut back in place and tightened nut
11. Put replacement outer grinder back in place and locked it in place
12. Checked distance between outer and inner grinder, factory setting of 5 was adequate (minimal to none metal grinding noticable
13. Put bean hopper back in place
14. Adjusted grind of beans
15. Adjusted setting for amount of coffee ground
-> now the setting is a little below 1/4 - >-> like new!

1. Remove coffee Bean hopped
2. Remove left over beans
3. Reinstall hopper and run grinder for remaining beans in the system
4. Remove hopper
5. Remove burr
6. Install new burr, reinstall hopper
7. Set courseness to maximum 13
8. Add beans
9. Run grinder while increasing from course to fine ... Read more until next desired setting

Caution, leaving at original fineness setting and installing new burr could lead to jamming the burrs.