This is a genuine OEM replacement part, it is made out of Metal with Fabric Filter Material. It is sold individually and is used on a variety of Lawn and Garden Equipment. This is an in-tank fuel filter which makes sure that the fuel delivered to the engine is free of any debris or contaminants. It will over time become clogged and restrict the fuel getting to the engine so it will need to be replaced.
Remove and replace each fuel line one at a time so you don\'t confuse where each line goes. It helps to cut the end of the line at an angle to make it easier to push into the tank. I also replaced the fuel filter. Snap the primer bulb out of the housing and snap the new one in. Again make sure you get the lines mounted to the correct loca
... Read moretions on the primer.
1- Empty the fuel tank
2- Make a hook with a wire and fish the fuel line and fuel filter out
3- Remove the old fuel filter from the fuel line, then install the new one
4- Remove the top cover
5- Remove the old air filter and replace it with the new air filter
5- Runs great now
Removed old gas filter by fishing it out of the fuel tank, removed air intake filter, disconnected fuel lines from carburetor and removed two capture nut, pulled off old carburetor and installed new one and reversed procedure to reconnect everything.
Cleaned old plug and reinstalled it, put in new Non-Ethanol fuel primed th
... Read moree engine gave it two pulls and away it went. Still has a slight miss, but has power again. Probably need to change the induction coil.
Replace gas tank and all gaskets. Replace air filter and filter cover with mount. Replaced primer bulb. Replace trimmer hub. Trimmer starts and running well now.
This was my first time to tackle a gas trimmer so it was a learning experience. I could not have done it without the help and tips from Replacement Parts!
Did you find this story helpful?
Thank you for voting!
The blower wouldnt stay running, just a few seconds
Removed air filter
Removed carburetor with a socket
Removed gas lines and throttle cable
Removed old intake gasket
Reassembled carburetor with new gasket
Replaced the fuel filter inside the tank
Primed the carb. Set the choke and throttle to full open
2 pulls it sputtered, 3rd pull it started
<
... Read morebr />It ran fine barely had to tweak the jets
Very happy with results
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
