Bearing 120-9272

1. Remove upper & lower cover.
2. Remove drive belt from auger shaft.
3. Remove drive pulley assembly to access auger pulley bolt.
4. Remove auger pulley bolt & pulley.
5. Remove pulley flange with gear puller.
6. Remove bolts from auger shaft bearing & remove auger bearing, bearing cups & thrust washer.
... Read more />7. Install new thrust washer, bearing & bearing cups.
8. Reinstall remaining parts in reverse order.
9. Adjust tension on auger drive cable.

1. Remove 6 10in bolts from bottom to top of the chute
2. Remove 4 13in bolts from blade sides, then remove two 13in bolts from chute hold bracket remove chute and belt cover
3. Tip forward to remove bottom cover to remove bolt from blade holder suggests use jack stands to hold the blower up .
4. Pull blade out from h ... Read more ousing, there you well see three bolts remove and to replace bearing and cup.
5. To reinstall repeat same steps from tear down.