This is a genuine Husqvarna replacement part sourced from the manufacturer. The 5/16-18 Unc shoulder bolt is constructed of high-quality metal, and is compatible with many lawn and garden engines. Please refer to equipment manual and diagram for the specific use of this item. A wrench and screwdriver are most often needed to make the proper replacement.
I removed deck from mower so I could see moving parts better. I am 73 years young and laying on my side looking under mower was not my cup of tea. Upon removing deck I could see the results of 11 years of use. The parts were worn extremely bad and were hanging up and not releasing the Idler pulley when moving lever to dis-engage blades
... Read more. I should have ordered 2 Arm assembly Pad Brake but as it turned out one was not worn as bad as the other. The job was relatively easy. Just removed spring tensions first and laid them aside. Proceeded to remove nuts from carriage bolt. Put new parts on and put deck under mower. Mowed an acre of grass and had no problems. On a parts quality note..... The Arm Assembly pad Brake has a bolt on end that has a roller on it that is used in the disengage mode. On the original arm it was a thru bolt with nylon lock nut. The new one is just pressed in and I think it should have been spot welded where it come thru the arm. Only time will tell. If a person has a welding machine I would highly recommend putting a spot weld there as that bolt at times will have a lot of pressure on it as it slides around the edge of idler arm.
Supported lawn tractor on stands.
Released deck belt
Removed spindle nut
Removed bolts on vented housing
Removed vented housing from dec
Removed blade
Removed spindle shaft
Reinstall:
Applied grease to bearing race surface
Reinstalled spindle and belt
Attached blade
Removed old rusted stretched springs
lubed hinges and replaced springs
worked broke bolts out with WD-40
Anti-sized new bolts and installed
Ground entire deck down, removed rust, primered and repainted
Mower deck repair completed
Dropped the mower deck
Removed the idler
Removed and replaced the brake arm assembly and the idler and associated washers
Replaced the idler arm and the brake arm assembly
Do not lubricate any of the replaced parts. Oil will contaminate with dirt and wear out quickly!!
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP9286074
Manufacturer Part Number: 532139888
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
