Washer Hardened Smaller 532133944

I removed deck from mower so I could see moving parts better. I am 73 years young and laying on my side looking under mower was not my cup of tea. Upon removing deck I could see the results of 11 years of use. The parts were worn extremely bad and were hanging up and not releasing the Idler pulley when moving lever to dis-engage blades ... Read more . I should have ordered 2 Arm assembly Pad Brake but as it turned out one was not worn as bad as the other. The job was relatively easy. Just removed spring tensions first and laid them aside. Proceeded to remove nuts from carriage bolt. Put new parts on and put deck under mower. Mowed an acre of grass and had no problems. On a parts quality note..... The Arm Assembly pad Brake has a bolt on end that has a roller on it that is used in the disengage mode. On the original arm it was a thru bolt with nylon lock nut. The new one is just pressed in and I think it should have been spot welded where it come thru the arm. Only time will tell. If a person has a welding machine I would highly recommend putting a spot weld there as that bolt at times will have a lot of pressure on it as it slides around the edge of idler arm.