Part Location Diagram of A100000720 Shindaiwa Piston
See part C-1 in the diagram
( Grid squares measure 1x1 inch )

Piston A100000720

Manufactured by:
Shindaiwa
ERP Number:
ERP9177818
Part Number:
A100000720
Original Equipment Manufacturer ?
$53.20
Special Order

Difficult 

1- 2 hours 

(1 rated repair) ?

Does this part fit my model?

Need help finding your model number?

Troubleshooting

This part works with the following brands:
  • Shindaiwa
This part works with the following products:
  • Trimmer
  • Hedge Trimmer

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Difficult 

1- 2 hours 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

piston ring cracked and scared both the piston and cylinder wall

david from NEW PORT RICHEY, Florida

3 of 3 people found this instruction helpful.
Difficulty Level:
Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers, Wrench set
the articulating hedge trimmer is $600 to replace and all other parts are working so a $70 repair was in order. This is only the 2nd time I\'ve replaced a piston on a small engine. Was up for the challenge.
Once the cylinder was removed, unclipping the C-rings which held the connecting rod to the piston shaft was pretty simple. N ew parts reverse order. A little tricky to \'compress the new rings on the new piston to get it to go into the cylinder but eventually successful.
Reassembly produced no spark, so had to ponder why. Closer look there are black plastic spacers on the old cylinder that aligned the coil to the magneto. partial disassembly and add the needed spacers, reassembly and all good. Have used the trimmer 3 separate times to date and all seems fine.
Did you find this story helpful?
Thank you for voting!
  • 1