The shift rod pivot attaches to the shift lower rod. It is a genuine item that is supplied by the original equipment manufacturer for use with Ariens blowers and snowblowers. This part is made of metal and is available individually. During the installation process, a set of pliers and a wrench might be needed to replace this item. It will require replacing if it becomes broken.
Troubleshooting
This part works with the following brands:
Ariens
Gravely
This part works with the following products:
Snow Blower
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
1. Replace the shift rod.
2. Replaced the cable for the chute lock
I didn\'t refer to any instructions when attaching these parts, it was fairly easy to figure out just by looking at the parts and the snowblower. I did have to play around with the adjustment for the cable of the chute lock to get it to work properly. After a
... Read morebout 3-4 attempts (about 20 minutes in total) I was able to get it just right.
Read less
Did you find this story helpful?
Thank you for voting!
Upper shift rod broke where it attached to lower shift rod & lower pivot sheared @ hair pin
This describes repair for Ariens 926101 (926LE 9HP)
1, Save you old parts and compare them in length to assemble new shift rod parts.
2. Overall length should be the same, as new shift rods are of different lengths.
3. Assemble upper & lower rods together with the saved carriage bolts & wing nuts.
4. First attach
... Read moreupper end of shift rod to speed control lever with hair pin
5, Place motion shift to fastest forward speed.
5. With pivot attached to lower rod, hold speed control lever (from blower housing) down, to lowest position & adjust pivot so it easily enters the hole in the lever from the rear. Then insert hair pin in the small hole of the pivot.
6. Place the motion control in the fastest reverse slot & the blower lever will move upwards.
7. After starting go for a test drive.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_7.gif "Part Location Diagram of 00386700 Ariens Pivot-shift Rod .375-16(trunn)")
_WW_7.gif "Part Location Diagram of 00386700 Ariens Pivot-shift Rod .375-16(trunn)")
