This replacement item is used with Dewalt grinders. It is an authentic part supplied directly from original equipment manufacturer. This cord delivers power from the outlet to the tool. If the cord is damaged or torn it is important to replace it immediately and not use the tool until replaced. It is constructed with tough, thick outer rubber insulation for a long service life. Please note the cord protector/grommet is sold separately. Replacing cord is a simple repair that should only require a screwdriver. • Remove housing screws • Separate housing • Disconnect wires • Remove old cord • Secure new cord in place • Reattach wires • Reassemble and test the unit
Handle needed to split in half to remove cord. Needed special torx driver to remove screws a flat bladed screw driver could also used. Two wire cord was removed and new cord was installed Wires on replacement cord were as with different lengths so they could only be installed one way. The Dewalt grinder is well designed for repair serv
... Read moreices
1. Removed cover.
2. Disconnected power cord from inside connections.
3. Installed new cord, connected to connectors.
4. Reinstalled cover.
5. Test drove!
I have a short cord that I saved from my other grinders, note: (I have 8 grinders) I am a structural welder. I removed the back half of the grinder and visually checked the brushes, they looked fine. I removed the cord and put on the short cord with out putting it together and plugged it in and it worked fine so I ordered 2 cords one for
... Read morea pair..
Grinder needed new brushes and the cord was damaged. Safety first, Put on eye protection. Cord was easily replaced by removing side cover and removing two screws holding cord wires to switch. Install cord protector on cord. Replace screws with new cord wires in place, reassemble cover. Brushes were also an easy remove and replace. Removed
... Read more brush covers by removing screw and opening cover. Pull back brush holder spring and lock on pin. Install new brushes by installing brush wire thru hole in brush holder and set brushes in holder and release brush holder spring from pin. Spring rest against brush holder, keeping tension between brushes and against armature. Plug brush wire into brush wire connector. Repeat for other side.Reinstall brush covers install screws to hold cover in place. Test Grinder for correct operation.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP11925999
Manufacturer Part Number: 330081-18
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
