This anvil assembly is for impact wrenches.
The anvil assembly is the output shaft that drives the socket. The assembly may include multiple parts; refer to your parts diagram for a complete list of parts included.
Disconnect the impact wrench from the power source before installing this part. Wear work gloves to protect your hands.
Troubleshooting
This part works with the following brands:
DeWALT
Black and Decker
Craftsman
This part works with the following products:
Impact Driver
Wrench
Part# 627238-00SV replaces these:
627238-00SV,
Videos For installing this part.
?
★
Customer Part Reviews
?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(3 Reviews)
Click to filter by ratings:
5 stars
3
4 stars
0
3 stars
0
2 stars
0
1 star
0
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Good quality
Fit great
Brent - June 8, 2021
Verified Purchase
★★★★★
★★★★★
Parts are easy to fine for products
Great customer service, I had to call to get the parts ordered. Received the parts in a timely manner. Glad I found this store on the web, will be purchasing more at equipment ages.
Anonymous - January 4, 2022
Verified Purchase
★★★★★
★★★★★
Super easy replacement
The original anvil broke off during rough use. Easy to find on site and while some may balk at the cost of the part, it's still way cheaper than buying a whole new tool. Pop out the 4 screws holding the nose cap on, pop out the old anvil and in with the new. Four screws back in and done. Simple!
Guest - March 22, 2024
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Replacing the anvil
1 Set the impact in a vise with the anvil facing up.
2 Remove the 4 screws holding the anvil housing on.
3 While lifting the housing off hold down on the tip of the anvil.
4 Remove and replace the anvil
5 Reinstall the anvil housing and install the 4 screws
Replacing the brushe
... Read mores
1 Remove the 4 screws holding the rear housing in place and remove the housing
2 Using a needle nose pliers carefully remove the terminal of the brush from the male terminal.
3 Using a screw driver lift the tension of the spring that is pressing down on the brush and pull the brush out with the needle nose pliers
4 Push the new brush into place and put the wire terminal for the brush back onto the male terminal
5 Reinstall the rear housing and 4 screws
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
