This is a genuine manufacturer sourced replacement part that is specially produced for use on Black and Decker and Dewalt power tools. This hardware has multiple different applications depending on the equipment. Please make sure to check appropriate diagrams for correct location and use of this screw. Note this Phillips head screw is sold individually.
Removed the crank, cover/shroud, chain guard, out-feed table.
Turned machine onto side. Gears up.
Removed split rings on three gears.
Pulled gear/chains from the three shafts: Motor /infeed roller/ outfeed roller
Once exposed to view, it was apparent that the REAR bearing block holes were egg shaped instead of r
... Read moreound. Here was the reason for the intermittent feed through.
Removed 4 screws holding retaining clips/bearing blocks/outfeed roller. (Watch out for roller tensioning springs behind bearing blocks.)
Checked the outfeed roller shaft for run-out. A few thousandths out. Decided to keep it, thinking the rubber coating probably absorbs some eccentricity; will replace later if it gets too noisy, or the smell of burnt rubber.
Ordered parts from diagram on web. (Note my model 733 had two generations. I mistakenly ordered replacement bearing blocks for the second generation, which do not fit. It would be better if the web page forced you to search by model number AND serial number. Eventually figured it out, re-ordered correct parts from the first generation parts list.)
Re-assembly was reverse of disassembly.
Fired it up. Ran several board feet of cherry through it. Behold: a fully functional, 25 year old DeWalt 733 planer. Repaired for pocket change.
BTW: I replaced the plastic chain cover because I broke the mounting tab when I took it off. Careful there. Replaced the 4 screws out of habit.
Eventually I\'ll get around to returning the wrong bearing blocks, but I suspect that if shipping is on me, then it will probably be more than the cost of the part. Souvenir then.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10173296
Manufacturer Part Number: 429991-05
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
