It is a genuine item that is supplied by the original equipment manufacturer for use with Makita finishing sanders. This is an identical replacement for a missing or damaged lever that helps to secure the sandpaper, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality component is sold individually.
Picked this up used sander to complete a refinishing project. It\'s an oldie but goodie. It had good bones, extremely well constructed. Ultimately I replaced the sandpaper clamps and retaining clips, the nylon feet that hold the base, the brushes and a seal.
Cleanup was extensive, I used 600 grit wet/dry paper VERY lightly on the a
... Read morermature to remove accumulated oxidation. All the bearings were tight, no attention needed.
Assembled the old sander, fortunately there are plenty of sources of exploded parts list to make sure you gat it back together properly.
In the end, I now have a Makita 1/4 sheet sander that runs like brand new and since all the wearable parts have been replaced should last a very long time. You would be hard pressed to find a new unit with this quality unless you plan to spend a great deal.
Remove pad screws and housing, in order to get to the lever
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
