A genuine item which is supplied directly from the original equipment manufacturer for use with Campbell Hausfeld air compressors. The purpose of this gasket is to provide an air-tight seal for the inlet valve, over time it may wear out and even begin to crack eventually requiring a replacement. Keep in mind this high-quality component is made of durable composite material and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware.
Troubleshooting
This part works with the following brands:
Campbell Hausfeld
This part works with the following products:
Compressor
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Removed head bolts. Removed air outlet bolts. Cleaned any existing old gasket material with putty knife, wire brush and fine grit wet/dry sand paper. Applied new gasket. No sealant. Assembled in reverse. New gasket did not seal, it was too thin. Proceeded to make my own gasket with a thicker gasket material I had laying around, it was twi
... Read morece as thick as the material used for the new one. Even the old one was thicker than the new one. Runs like new with no leaks. This air compressor is about 35 years old and has almost all original parts.
Read less
Did you find this story helpful?
Thank you for voting!
This was an old compressor maintenance issue. The intake cover was removed for inspection and screen cleaning. Gasket had been stuck and broke when removed. Intake has spider webs on screens.
Removed intake metal plate which had 2 long hex head bolts. Took gasket out which was in very dry and brittle from heat and stuck in places to intake base metal. Sprayed brake cleaner solvent on gasket that stuck to head and bottom of plate. Scraped carefully softened gasket off with putty knife. Took intake cover plate and used a bench
... Read moregrinder wire wheel to clean bottom of plate. Reinstalled new gasket and reinstalled the two hex heads and carefully tightened them. The head plate was removed which had 5 small short hex head bolts and the same cleaning procedure was used with gasket surface cleaning and using grinder wire brush to remove residue on bottom of top plate. After cleaning reinstalled the new gasket and plate. Installed the five small hex head bolts and tightened in cross hatch pattern completed in less then 60 min.
Remove cover plate
Remove filters
Remove gasket from cover plate
Replace cover plate and gasket
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
✖
[{"position":0,"name":"Home","title":"Home","url":"/"},{"position":1,"name":"Seal or Gasket","title":"Seal or Gasket","url":"/parts/power-tool/compressor/seals-and-gaskets/"},{"position":2,"name":"XA009500AV","title":"XA009500AV","url":""}]
