Genuine Manufacturer Sourced replacement part used on Walk-Behind Push Mowers. This is the Belt which connects to the Transmission and allows mower to mower forward. This part is made out of Rubber and it is Sold Individually. Clean the pulleys off before installing the new belt to ensure top performance and longevity with your new belt. Inspect belts periodically and replace them when worn to maintain peak performance.
1. Watched your video. https://www.youtube.com/watch?v=_NkyFS1dKXk
2. Removed old belts following your disassembly directions
3. Replaced belts and reassembled tiller.
Removed belt shield , removed lower belt shield, loosened belt guides, removed drive pulleys from transmission drive, removed old belts , then did everything in reverse to put back together with new belts and springs in place!
1. Removed the plastic cover to gain access to belts and reverse cable connection. Unbolt and remove lower pulley and woodruff key. Replace belt or belts on pulley and reassemble.This must be done due to close tolerances with tiller frame. Also when removing the pulley bolt you must keep the drive shaft from turning. There is no flat spot
... Read more on the shaft to hold it with a wrench or a hole to put a spud wrench into to keep it from turning . Take a rope and tie it to a tine and the other to the frame. FYI : pulley bolt is NOT a reverse thread. As far as replacing the reverse cable goes , itÆs pretty straight forward.
Took off the belt cover and bottom guard. Had to deflate the tires to get the wrench to remove the the back screws to the bottom guard. Pulled the bolt that held the pulleys. and put belts on pulleys and reattached to machine
Removed old belts and installed new ones. took cowling off and removed drive pulley put belts around pulley and reinstalled. My main story is to commend E Replacement Parts. What a great system you have for looking up and ordering parts. My tiller is old but finding the right parts was a breeze and were exact replacements. One was back or
... Read moredered but you kept me informed and it wasn\'t long and they were on the way. I have never had a wrong part from you folks and I have ordered quite a few. Thanks for being a great company!
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
