This is a manufacturer approved replacement part used on a variety of lawn and garden equipment engines. This filter adds a second layer of protection against airborne-dirt particle ingestion. This is a foam pre-cleaner which is sold individually. Please note a paper filter and a cover are both sold separately. No tools are needed to replace this filter. • Remove the filter cover • Take out the old filter and replace it with a new one • Secure the top cover
In my case, removed front sheet metal (hood and grille) from mower to expose front of carb, where fuel pump is located. Easy disassembly of fuel pump (3 screws with 1/4\" hex heads). Take care with the two small, fine springs and the new pump diaphragm so they are replaced correctly. No need to disconnect vacuum hose from pump cover, but
... Read morecheck it carefully for holes or cracks. Reassemble with new kit parts and you should be good to go. My engine ran well afterward and even started better than before.
Read less
Did you find this story helpful?
Thank you for voting!
The engine on my garden tractor would only run smoothly with the choke pulled out half way
Watched youtube videos of carb repairs for my tractor and engine. Disassembled the air filter housing and removed the choke cable from the carburetor. I removed the top of the carb and replaced the needle valve. I cleaned out the carb body but did not remove the carb from the intake manifold. I reassembled the carb top with new gasket
... Read mores supplied in the kit. Reinstalled the air cleaner with a new filter and pre filter foam. I swapped in the new spark plugs and it started right up and runs with the choke all the way in! Job done!
Read less
Did you find this story helpful?
Thank you for voting!
Oil pan gasket was leaking, wouldn\'t stay running & front wheels loose
Drained oil, removed engine, turned it over, removed pan, cleaned and installed new gasket {gasket was ordered earlier}, reinstall engine, refill oil. Rebuild gas pump & clean carb. Removed front wheels,hammered out bushings installed new ones, easy peasy!
Carburetor was leaking fuel. Ordered kit and installed. Installed carb back on engine and attached linkage, choke cable, fuel line. Installed new air cleaner filter and pre filter. Kit and instructions were easy and precise.
Did you find this story helpful?
Thank you for voting!
Engine did not run properly except on partial choke.
Remove the air cleaner. Removed the carburetor and rebuilt. Advice: Take lots of pictures to reassemble properly.
I also watched ereplacements video- https://www.youtube.com/watch?v=faM2nla4_u4
Just a regular annual maintenance, replaced both main filter and the foam pre-filter. Place the foam filter over the main paper filter, simply remove the cover and replace the air filters.
1. replaced the air filter and outer sponge.
2. replace fuel filter
3. used push not to secure the bolt on flapper.
4. i had a oil filter ordered and my Briggs & Stratton engine did not require one.
How can I return the oil filter for a credit?
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
