1. Place new bearing in freezer over night
2. Remove upper wheel
3. Tap old bearing out
4. Place wheel in the sun to warm it up. (Note: the wheel is cast aluminum so do not heat with a torch or any other heating device. Warming in the sun is good enough)
5. Apply thin layer of machine oil to bearing housing of whee
... Read morel
6. Start frozen bearing into bearing housing as far as it will go.
7. Use a piece of scrap hard wood and a hammer to completely seat the bearing.
8. Re-install upper wheel.
9. Re-install blade.
Remove the cutterhead from the jointer. Remove the pulley from the cutterhead by loosening the set screws and pulling on the pulley and removing the shaft key. Use a bearing puller to remove the old bearings. Then use a socket the same size as the inner race of the new bearing to tap the socket with the hammer, to seat the bearing on the
... Read morecutterhead. Then install the pulley and the cutterhead back on the jointer.
Read less
Did you find this story helpful?
Thank you for voting!
Roller bearing on blade guide wore out and wouldn\'t spin causing blade to spark from friction
Jeffrey from PEPPERELL, Massachusetts
1 personfound this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers, Wrench (Adjustable), Wrench set
I removed the main table and then disassemble the guides holding the bearings. Then I removed the bearings from the guide by releasing the snap rings, sliding the bearings off the shaft and replacing them with new ones along with the bearing spacers. Then I reassembled the bearing assembly and reinstalled the main table.
Removed jointer knife head assembly.
Pressed old bearings from assembly carefully marking right and left bearing mounts before removal.
Pressed new bearings into assembly.
Mounted assembly back into jointer base.
Checked alinement and bold torques.
Made final jointer table alinement adjustments and started j
... Read moreointer.
Read less
Did you find this story helpful?
Thank you for voting!
Lower bearing bracket casting was cracked in half.
1. Removed the band saw blade.
2. Removed the table
3. Removed the bracket and the bearings.
4. Replaced the bracket and the bearings.
5. Repeated the steps in the reverse.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10463886
Manufacturer Part Number: BB-6202ZZ
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
