Search By Model Number
This is an original part from Whirlpool for use with stand mixers. The worm bevel gear meshes with the worm gear, causing the rotation of the planetary assembly where the accessories attached. The most common reasons for replacing the worm bevel gear is if the teeth are worn out or damaged, or you hear the motor come on but nothing is moving. This part is sold individually. Here is a list of tools that are needed to replace the bevel gear a flathead screwdriver (large and small), hammer, punch, Phillips screwdriver (large and small), large Phillips driver ratchet, rubber mallet. Optional: towels and a U-shape holder.
This OEM authentic part is to be used in stand mixers made by KitchenAid and Whirlpool. It is an important part of the mechanism that drives the beaters. The gear is made of metal, unfortunately, over time the teeth may wear out. Worn gears may not spin at the proper RPM, if it spins at all, so replacing the gear will help bring the mixer\'s performance to like-new levels. This part is sold as an individual item. Please refer to the owner\'s manual and diagrams of your model to ensure the proper installation. Note, when replacing this part, to help reduce friction, planetary grease is required.
Genuine KitchenAid replacement part
This brush is sold individually, 2 are needed for the Mixers shown below
It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that’s operating intermittently. These brushes are keyed and will only go in one way to work correctly.
• Flat Head Screw Driver
This replacement part is supplied directly from the original equipment manufacturer. It is specially designed for Whirlpool stand mixers. The worm gear is part of the drive system that rotates the attachments for your mixer. It is driven by the gear on the end of the armature. Over time the part may wear out or get damaged eventually requiring a replacement to ensure the unit is functioning properly. Keep in mind this high-quality worm gear is made of durable plastic with metal and is sold individually. Refer to the diagrams of your model for the correct installation of the new part.
This is a genuine Waring replacement part. Sold individually.
This gasket provides a tight seal between the main blender jar and the blending assembly, preventing liquids from leaking out. Made from food grade Silicone Rubber.
No tools are required for repair, simply replace the gasket and continue blending.
This part is compatible with the Waring blender models listed below.
Browse Mixer Parts
Mixer Repair Videos
Mixer Repair Articles
|How to Diagnose a Bad Power Cord or Switch||How to Replace the Circuit/Phase Board on a KitchenAid Stand Mixer|
|This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool...||A bad phase board in a stand mixer can cause it to run on full speed even when you've set it to slow. This article expla...|