Maytag
We sell only genuine Maytag ® parts.
Popular Categories
Maytag Replacement Parts by Category
Popular Parts
This is an authentic KitchenAid part. This screw is used on many bowl lift style KitchenAid mixers to secure the Bowl Spring Latch (Part number 3182857) into place. This screw is a slot headed screws that is made of steel. You can rest assured ordering this screw knowing that it has been made specifically KitchenAid mixers. This screw will correctly fit and retain the Bowl Spring.
This is a genuine component which is specially designed for use with Whirlpool washers. It is supplied directly from the original equipment manufacturer. This item provides a high-quality replacement for a missing or a faulty hardware that was installed on a new unit. The screw helps to secure the agitator. Please make sure to refer to the appropriate diagrams of your model for the correct application of this part. Keep in mind this high-quality item includes one durable metal screw and one washer. Replacing it is a simple task that should only require a small wrench.
This is an authentic OEM part from Amana, Speed Queen, Kenmore, Whirlpool, Maytag, Crosley, KitchenAid, Magic Chef, Admiral, Inglis for use with Dryer, Washer, Washer Dryer Combo. The washer is found on dryers around the drum support rollers and idler pulleys and helps prevent the rollers and pulleys from bumping up against the brackets they are installed on. The thrust washer has a 3/4 inch outside diameter. The most common reason for replacing the thrust washer is if it is worn out or the pulley becomes noisy. This part is sold individually. Here is a list of tools that are needed to replace the thrust washer a 5/16” nut driver, putty knife, towel, container, 1/4” nut driver, pliers (optional), Torx-20 screwdriver, 13mm socket wrench with extension and a flat blade screwdriver.
This is an original part from Whirlpool, Maytag, International, Jenn-Air, Crosley and Roper for use with Dryers. The support roller shaft attaches the support roller to the dryer and provides a place for the roller to rotate. The most common reason for replacing the roller shaft is if the bearing in roller went bad and gouged up the surface of the axle shaft. This part is sold individually. Here is a list of tools that are needed to replace the roller shaft are a Phillips screwdriver, 5/16” nut driver, snap ring pliers, flathead screwdriver, and 1/2” wrench. Unplug the dryer before installing this part.
This is an authentic OEM part. The Whirlpool suspension spring is made for use with many washing machines. The metal spring gives support to the outer tub. This item helps to maintain the balance of the appliance when in operation. The suspension spring is sold individually. A screwdriver and needle nose pliers are necessary for the replacement.
Join our VIP Email list
Receive money-saving advice and special discounts!
Thank you!
Error
