Dryer Parts

This is an authentic OEM part for use with Whirlpool Dryers. The Thermal fuse shuts off the heating element when the dryer overheats. The two most common reasons for replacing the thermal fuse are when the dryer doesn't heat or won’t start. This part is sold individually. The tools that you will need to replace the thermal fuse are a hex socket, flat head screwdriver, Phillips head screwdriver and a putty knife. We recommend checking to make sure all of the vents are clear when you perform this repair.

This is a genuine component that is supplied by the original equipment manufacturer for GE dryers. The green drum slides are used to support the weight of the drum. The most common reason for replacing the drum slides are when they begin to make noise due to being worn out. These are sold separately and it is recommended you purchase two to replace both at the same time.

This is a genuine OEM sourced replacement drum bearing slide designed for GE residential dryers. The dryer's drum slides help to support the front of the drum as it rotates. There are two (2) per dryer. They attach to the outer-most sides of the bearing. It is advised to replace both sides at the same time. This item is made out of white plastic and it is sold individually.

This is a genuine OEM part. The timerdefrost (60 hz ,120 v) is compatible with many refrigerator appliances. This item is secured to the defrost circuit in the freezer control housing. The timerdefrost manages the defrost heater, melting the excess ice from the coils. the timerdefrost is sold individually. A screwdriver is required for installation.

This is a genuine manufacturer-sourced component which is specially designed for Whirlpool washers. The most common reason to replace the drive belt is if it is broken and the dryer drum is not turning. This part is sold individually. Tools needed to replace the drive belt a small flat head screwdriver or putty knife and a Phillips screwdriver.