We sell only genuine Delta ® parts.
Enter Your Model Number
Delta Replacement Parts by Category
Band Saw Parts
Base / Stand Parts
Chop Saw Parts
Drill Press Parts
Dust Management Parts
Fence / Rail Parts
Genuine OEM replacement part
This brush is sold individually, 2 are needed for the tools shown below
It is always best to replace both brushes, even if only one is worn.
Worn brushes frequently are the cause behind a motor running poorly.
Replacing brushes can fix a motor that’s operating intermittently.
New brushes can restore a motor’s electric braking.
Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.
This is a genuine Porter Cable replacement part, it is sold individually.
The purpose of the N044359 Tube Seal is to prevent an air leak.
It is placed on the outlet tube coming from the head of the compressor.
This is a genuine Black and Decker replacement part, it is sold individually.
This part acts as a secondary air filter for the models shown below.
Its purpose is to filter out dust and debris from contaminating and damaging the motor assembly.
To remove the filter take off the front of the unit and remove the filter from the cover that it is located in.
Its a good idea to also blow out the cover to clean it out.
This is a genuine OEM replacement part, it is sold individually.
This Charger is used on the tools listed below.
When a battery is inserted into the Charger, the red indicator light will come on indicating that there is contact between the battery and the Charger.
The light will stay on as long as the battery is in the Charger and the Charger is plugged into a working outlet.
When you use a compressor the air that is compressed inside the tank will condensate and leave water inside the tank.
If it is left in the tank too long it can start to rust out the inside of the tank.
The Drain Valve should be opened up and let the water drain out.
The water will build up if you have a tendency to leave air in your tank for a long period of time.
You should drain your tank after each time it is used to prevent this from happening.