866-322-9842
Mon-Fri 7am-1am EST
Sat-Sun 7am-11pm EST
Repair Parts Home  Lawn Equipment Parts  Husqvarna Parts  545081848 Carburetor Kit

Carburetor Kit

Part Number: 545081848
Husqvarna
Availability: 25+ in stock
Price: $34.19
Quantity:
Ships within 1 business day

*This part replaces obsolete part #: and 5450060-62.

Description:
Genuine Manufacturer Approved Carburetor Kit which includes a Metal Body Carburetor and a Carburetor Gasket. It is used on some Husqvarna Gas Powered String Trimmers. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won\'t start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem.
Product Information
Manufacturer: Husqvarna
Product Number: 545081848
Classification: Part
Weight: 0.31 lbs.
Shipping: Ships Worldwide
Related Products
Products Compatibility

This item works with the following types of products:

  • • Edger
  • • Trimmer
Questions & Answers

No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
14 of 14 people found this instruction helpful
Tool Type:
Trimmer
Parts Used:
Carburetor Kit - 545081848
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Power Drill, Socket set
Trimmer was starting, running for 3 minutes then stalling.
Remove the air filter assembly, remove the fuel lines and throttle from the old carburetor. Note where the fuel lines went. Remove the old carburetor and gasket and install the new ones. Install the air box to secure the new carburetor. Install the fuel lines and throttle. Install the filter and filter cover. Press the primer a few times, choke it until it kicks over, open the choke, and you should be running.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
7 of 7 people found this instruction helpful
Tool Type:
Trimmer
Parts Used:
Carburetor Kit - 545081848
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Nutdriver
Carburetor problems
Remove the air cleaner cover then the air filter. Remove the fuel lines and throttle ( pay attention where the fuel line went) Remove the two nuts holding the air box and carburetor. Remove the old carburetor and gasket. Then install the new gasket and carburetor and tighten up the two nuts behind the air box. Install the fuel lines and throttle. Then the air cleaner assembly.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
7 of 8 people found this instruction helpful
Tool Type:
Trimmer
Parts Used:
Filter - 530150253
Carburetor Kit - 545081848
Gasket Foam Kit - 545008084
Repair Difficulty:
Medium
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Pliers, Nutdriver
Would not start. Carburator was plugged up and would not deliver fuel with plunge bulb. Tried carb and choke cleaner. Spark was good.
1st Drain remaining fuel and discard. Unpacked the new parts and familiarized with all.Took off cover with nut driver. Discarded used air filter and replaced it with the new one and set it aside. The throttle cable and fuel tubing were removed with needle nose pliers. Removed the old carburetor. Removed old gasket and installed the new. Replaced the old carb with the new. Without cover the carb is loose for attaching the throttle cable first and then the fuel tubing. Used needle nose pliers to attach the throttle cable and to attach the tubing to the new carb and carefully slid them up snug to the carb. Tested the throttle and it worked properly. Replaced cover. Tightened cover nuts with nut driver. Added fresh oil and gas mix. Pumped the new plunge bulb about 4 to 6 times, with no throttle pulled 2 times at full choke, and then on 3rd pull at half choke it fired up. I let it warm up for10+/- seconds and flipped off the choke. Idle is slightly high but haven't changed it with the idle adjust screw yet. Went right work and it ran for about 2 hours like it was brand new.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
4 of 4 people found this instruction helpful
Tool Type:
Trimmer
Parts Used:
Carburetor Kit - 545081848
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Screwdriver, Socket set
Carburator replacement
1- Remove the air cleaner
2- Remove the fuel lines and throttle from the old carburetor
3- Remove the nut holding the old carb and gasket on
4- Place the new gasket and carb on and tighten the nuts
5- Place the fuel lines and throttle on the new carb.
6- Install the air cleaner assembly
Did you find this story helpful?
Thanks for voting and helping fellow customers!
4 of 4 people found this instruction helpful
Tool Type:
Trimmer
Parts Used:
Carburetor Kit - 545081848
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Pliers
Carburetor was leaking gas.
Remove the air cleaner assembly, Then remove the fuels lines (Note where the fuel lines were connected) and the throttle cable from the old carburetor. Install the fuel lines and throttle cable on the new carburetor. Then install the air cleaner assembly.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
2 of 2 people found this instruction helpful
Tool Type:
Trimmer
Parts Used:
Fuel Line - 530069599
Fuel Filter - 530095646
Filter - 530150253
Assy-Cap W/Ret - 578931503
Carburetor Kit - 545081848
Repair Difficulty:
Medium
Time Spent Repairing:
30-60 minutes
Tools Used:
Pliers, Socket set
Carburetor had had ethanol gas run through it. Needed replacement.
Repair was simple. Most difficult part was replacing fuel and return lines. Cut lines at an angle, put oil on them, push through hole and grab with a pair of hemostats and pull. Not sure pliers would work. Other than that simple.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
1 of 1 people found this instruction helpful
Tool Type:
Trimmer
Parts Used:
Carburetor Kit - 545081848
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Nutdriver, #25 torx bit
Trimmer would only run with choke turned halfway on and would not accept any throttle.
1. Remove air filter cover and air filter.
2. Remove two visible hex nuts.
3. Remove plastic cowling over carburetor.
4. Remove fuel lines. Push lines of carburetor fittings with flat blade screw driver.
5. Gently pull carburetor from side of engine.
6. When clear of the studs, unhook throttle cable from carburetor. Remove gasket.
7. Install gasket, hook throttle cable in carburetor and slide carburetor over studs.
8. Reinstall remaining parts. Do not over tighten hex nuts.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
1 of 1 people found this instruction helpful
Tool Type:
Trimmer
Parts Used:
Carburetor Kit - 545081848
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Socket set
Weed eater only run with choke on.
Removed the plastic cover.
Removed nuts holding carburetor.
Removed gas lines.
Removed carburetor.
Installed new carburetor re-attach gas lines.
Done.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Trimmer
Parts Used:
Carburetor Kit - 545081848
Fuel Tank Assembly - 545180870
Airbox - 576459001
Gasket Foam Kit - 545008084
Repair Difficulty:
Easy
Time Spent Repairing:
More than 2 hours
Tools Used:
Screwdriver, Pliers, Socket set, Wrench Set, Adjustable Wrench
carburator bad, would not start and will run then stop, hard to start.
changed carburetor , fuel tank assembly , gaskets and airbox cleaned up trimmer before repairs to be made , works like NEW unit thanks for the replacement parts , accurate and precise parts , worked without hessentation.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Trimmer
Parts Used:
Carburetor Kit - 545081848
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Socket set, Wrench Set
Carburetor
Easy
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Discussion
Discussion for Carburetor Kit - ( 545081848 )
Discussion is closed. To ask our experts a question about a part, use the Q&A feature.
Question: Adjusting The Idle On Carb

1302793

my engine will not idle when I let off the gas it just dies
WJA
Hello 1302793,

You may have some dirt and debris in the small passages in the carburetor. We have an article and video on How to Clean a 2 Cycle Engine Carburetor. Hope this helps.

-WJA
Question: P/N 545081848 For Husqvarna 128C...

1193458

What parts are included in the carb kit? Also, is the tool available to fit the idle mix adjuster screws? These and the welch plugs must be removed to clean the idle and of idle passages.
If these parts and the tool aren't available, is the carb available?
WJA
Hello 1193458,

The manufacture does not supply a carburetor repair kit for this model. The part number 545081848 Carb Kit includes the new carburetor and gasket.

-WJA
Reviews
4.6
Average Rating (out of 5):
5 Reviews
Click to filter by ratings:
5 stars
3
4 stars
2
3 stars
0
2 stars
0
1 stars
0
  • Highest Rating
  • Most Recent
< PREV
  • 1
NEXT >
  • Worked as usual
    Have bought quite a few different parts,all have worked as expected. All have fit with no problem. Thanks for providing this service!!!!!!
    Jj - July 4, 2019 Verified Purchase
    Part All Good
    New carb identical to original for my string trimmer, works just fine, easy install
    Guest - June 29, 2019 Verified Purchase
    Started on the third pull!
    The part that I purchased was a carburetor for my weed wacker, installed easily and started on the third pull. The weed wacker is just like new again.
    Guest - June 24, 2019 Verified Purchase
    Great Carburetor
    The carburetor arrived in a timely manner and was easily installed following the included instructions. Trimmer started on the second pull.
    Guest - June 29, 2019 Verified Purchase
    Easy repair, quick delivery
    Good quality part, easy installation. Needed a little adjustment but runs great now. Arrived quickly in good condition
    Guest - June 18, 2019 Verified Purchase
    Verified Purchase
    eReplacementParts Team
    • Highest Rating
    • Most Recent
    < PREV
    • 1
    NEXT >
    visa mastercard discover american express PayPal
    HACKER SAFE certified sites prevent over 99.9% of hacker crime.

    fancyboxy