This replacement part is specifically designed for use with Bosch drills/hammers. It is supplied by original equipment manufacturer and it is sold individually. This t-head bolt helps to secure support clamp to the auxiliary handle. When replacing this bolt you may need pliers.

Genuine Bosch replacement part.

Includes 2 Carbon Brush with wire lead and brush spring attached.

• Worn brushes are often the cause of a poorly running motor
• Replacing brushes can fix an intermittent motor
• New brushes can restore a motor’s electric braking

Carbon motor brushes are one of the most commonly replaced power tool components.  Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement.  Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power.  A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned.  When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

Genuine Bosch replacement part
rnSet of 2 Carbon Brushes with wire lead and brush spring attached.rnrn

• Worn brushes are often the cause of a poorly running motor
• Replacing brushes can fix an intermittent motor
• New brushes can restore a motor’s electric braking

Carbon motor brushes are one of the most commonly replaced power tool components.  Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement.  Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power.  A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned.  When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

Genuine OEM Replacement Selector Knob Assembly for Bosch Rotary Hammers/Drills. This part is sold Individually and it is made out of Plastic. To remove the knob from the tool you would need to turn it all the way counter clockwise then push the red button. Then keep turning it counter clockwise until the knob lines up with a keyed slot so you can pull it out.

This is a genuine OEM sourced item, it is sold individually. This petroleum based grease is designed for use with Bosch hammers. It helps to lubricate the system allowing fro easy movement and protecting parts from usual wear.

This is a manufacturer sourced replacement part used on a Bosch power tools. It includes two (2) carbon brushes with lead wires attached and two (2) coil springs.

Carbon brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. It is recommended to replace both brushes at the same time.

You would need a screwdriver and pliers to complete this job.

• First remove screws holding the cover together
• Separate two (2) halves of the housing to gain access to armature and brush holder
• Remove the old brush assembly
• Install the new brush assembly
• Reassemble and test your tool