Genuine Manufacturer Sourced replacement part used on a variety of Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Included in part number 605511-00

Genuine OEM replacement part, this item is sold individually.
This screw is used in various places in all of the tools listed below
The most common use for this screw is to secure plastic housings together.
It has a Torx T-20 head.

It is a genuine replacement screw that is sourced directly from original equipment manufacturer. This is a standard hardware that has multiple uses depending your tool. For correct location and use of this screw, please check appropriate diagrams. This torx screw is sold individually.

This screw is a standard hardware that has multiple applications depending on the model of your tool. It is an authentic replacement part that is sourced directly from original equipment manufacturer. For correct location and use of this screw, please check appropriate diagrams. This phillips head screw is sold individually.

This is a genuine OEM replacement part used on a variety of saws. It helps to distribute the pressure evenly and provides a tight seal for the connecting pieces inside the reel. It has multiple applications based on your tool. This part is made out of metal and it is sold individually.

To replace it you would need a screwdriver.

Genuine Black and Decker replacement part
This brush is sold individually, 2 are needed for the tools shown below
It is always best to replace both brushes, even if only one is worn.

Worn brushes frequently are the cause behind a motor running poorly.
Replacing brushes can fix a motor that’s operating intermittently.
New brushes can restore a motor’s electric braking.

Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problem