Admiral
We sell only genuine Admiral ® parts.
Enter Your Model Number
Popular Categories
Admiral Replacement Parts by Category
Same Day Shipping
Toll Free Support
Repair Help & Videos
Commonly Purchased Parts
See More +
Popular Parts
Clip, Retaining
Tools Needed:
• Retaining Ring pliers
Part Number: WP9703438
In Stock, 4 available
$6.67
This is an OEM part from KitchenAid. This Retaining Clip is used in all KitchenAid stand mixers. The Clip is made of metal. This part is used on the Agitator Shaft to hold the Pinion Gear into place. This part is commonly replaced with part number 9707627 Pinion Gear, part number 9708191 Agitator, and part number 9706090 Washer. The Retaining Ring can be damaged when removed when performing a different repair or easily lost.Tools Needed:
• Retaining Ring pliers
Thermal Fuse
Part Number: WP3392519
In Stock, 25+ available
$20.88
This is an authentic OEM part for use with Whirlpool Dryers. The Thermal fuse shuts off the heating element when the dryer overheats. The two most common reasons for replacing the thermal fuse are when the dryer doesn't heat or won’t start. This part is sold individually. The tools that you will need to replace the thermal fuse are a hex socket, flat head screwdriver, Phillips head screwdriver and a putty knife. We recommend checking to make sure all of the vents are clear when you perform this repair.
Drip Bowl (8-Inch)
Part Number: WPW10196405
In Stock, 17 available
$8.00
It is a genuine item that is supplied directly from the original equipment manufacturer for use with Whirlpool ranges. The drip bowl sits below the burner and it is utilized catch spills. It provides an identical replacement for a faulty or a missing component that was installed on a new unit. To ensure the correct installation of this part, make sure to refer to the appropriate diagrams of your model. This high-quality component is made of durable metal and is sold individually. To replace it no tools would be needed, simply remove the burner element, remove the old bowl, align the hole on the drip bowl with the burner element and secure it in place.
Drive Belt
Part Number: 341241
In Stock, 25+ available
$16.60
This is a genuine manufacturer-sourced component which is specially designed for Whirlpool washers. The most common reason to replace the drive belt is if it is broken and the dryer drum is not turning. This part is sold individually. Tools needed to replace the drive belt a small flat head screwdriver or putty knife and a Phillips screwdriver.
Door Switch
Part Number: WP3406107
In Stock, 25 available
$31.45
It is a genuine item that is supplied by the original equipment manufacturer. This part is made for use with Whirlpool residential dryers. The door switch acts as a sensor to allow the washer to start when the door is closed. Unfortunately, over time it may wear out, get damaged or stop working all together eventually requiring a replacement. If the dryer does not start then the door switch could be defective. Note, this high-quality plastic body assembly is sold individually. To replace it, you will need a screwdriver to take the housing apart. The switch simply connects to the unit with an attached wire harness.