We sell only genuine Southland ® parts.
Enter Your Model Number
This is an authentic manufacturer approved replacement part used with a variety of handheld lawn and garden equipment. A spark plugs purpose is to deliver electric current from an ignition system to the engine. Over time spark plugs will begin to fail requiring replacement. This item is sold individually.
You should gap your spark plug according to the owners manual of the outdoor product you have. To install or remove a spark plug a wrench or a socket wrench will be needed.
This manufacturer-supplied replacement part is designed for Southland and Powermate rear tine tillers. The clutch rod is an important component which controls the forward motion of the unit. It is an identical replacement for a missing or a faulty hardware that was installed on a new equipment. To ensure the exact location and the correct installation, refer to the diagrams of your specific model. Keep in mind this high-quality clutch rod is made of a durable metal and is sold individually. You will need pliers to remove the old part and attach the new one.
This is a manufacturer authorized replacement part designed for use with cultivators. The purpose of a carburetor is to mix air and gas before the fuel mix goes to the engine.
If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem.
This assembly includes a metal body carburetor with a rubber primer bulb. When replacing carburetor it is advised that you also replace carburetor gaskets to ensure proper air tight seal for optimum performance. You will need a screwdriver to perform this repair.
This clutch cable is supplied by the original equipment manufacturer. It is an authentic component which is designed for use with Southland and Powermate tillers. The cable helps to engage and disengage the forward and reverse drive function of the equipment. Check the correct diagrams of your model for the installation and application of this part. It is a high-quality rubber insulated clutch cable is sold individually. Please note, the housing, the trigger, and the hardware are all sold separately. You may need pliers and a wrench set to perform this repair. Note, the clutch rod that the cable connects to is sold separately.
This part has been sourced from the original manufacturer to be used with lawn edgers from Powermate and Southland. The metal blade can wear down over time and begin to shred the lawn. If the blade wears down it will need to be replaced to maintain clean edges around the lawn. This blade is available as an individual replacement part.