It is a genuine OEM sourced screw, it is not an aftermarket imitation. This high quality hardware is specially designed for use with Ridgid and Ryobi drills and drivers. It is generally used to secure the drill chuck. Includes (1) torx screw per order.

This high quality 12V nickel–cadmium battery is specially designed for use with cordless Ridgid power tools. It is an authentic OEM sourced item, not an aftermarket imitation. Over time batteries will get weaker no longer being able to hold charge. Several factors can cause this, such as the way the tool is used or just the normal deterioration of the battery. Please note, this item is sold individually.

This switch assembly includes the trigger switch, connected by 2 leads to a battery connector. The switch also has a heat sink, 2 terminals, and a forward/reverse lever already attached. Loose in the package are a tube of woven insulation material and a wire. This authentic Ridgid replacement part is sold individually.

Switches are commonly replaced parts in power tools. A switch handles all on/off and variable speed functions. They also have a role in electric breaking; they can momentarily reverse electrical polarity. Because switches use mechanical internals, they tend to degrade and wear out over time, eventually requiring replacement. Some common signs of a broken or failing switch are:

This replacement battery is a genuine OEM sourced part that is designed for use with cordless Ridgid power tools. Over time batteries tend to deteriorate and loose ability to hold charge. Please note, a defective charger can damage this battery. One 18 volt nickel–cadmium battery is included per order.

This is an Authentic Manufacturer Sourced replacement part used on a Ridgid Hammer Drill/Driver. This Assembly consists of: Plastic Ring Holder, Four (4) Metal Brush Holders with Springs and Four (4) Carbon Brushes with a Lead Wires Attached.

To replace this assembly you would need a Screwdriver

• First remove Screws holding the cover together
• Carefully remove Two (2) Halves of the housing to gain access to Motor Housing
• Disconnect the Wires from the Brush Assembly
• Remove the old Brush Assembly and replace it with the New Brush Assembly
• Reconnect the wires
• Reassemble and test your tool