Hoover Upright Vacuum Filters

This is a genuine Hoover-made filter used in WindTunnel and Elite vacuums. It fits inside of the dirt cup lid. This filter is designed to be rinsable; for best performance, rinse it every two months or if System Check Indicator light is on. Replace it when damaged or when rinsing no longer cleans it. This filter is sold individually. To Clean This Filter: • Hold filter under running water for a...

This is an OEM sourced replacement part designed for use with Hoover vacuums. This filter helps to keep the air clean. This part is made out of plastic with paper filter material and it is sold individually. No tools are required to replace this Filter. You can simply remove the old filter from the vacuum cleaner and replace it with the new one. Designed according to strict HEPA standards, the m...

This genuine Hoover filter is designed for use with the Wind Tunnel and Air Steerable vacuums. It sits inside the lid of the dirt cup and acts as the primary dirt filter. This filter is designed to be washed and reused. It should be replaced when damaged or when the filter is no longer cleanable. It is sold individually.

This is a genuine manufacturer sourced replacement foam filter that is specially produced for Hoover vacuums. Its purpose is to filter out dust and debris from the air. This foam filter element is sold individually. Replacing this item is a simple task that does not require any tools. • Simply remove the cover cap • Remove the old filter • Secure the new filter in place

This is a genuine manufacturer-approved replacement part which is specially designed for use with Hoover equipment. The purpose of this component is to ensure that the air that goes through the unit is free of dust and other harmful contaminants. Unfortunately, over time the material may wear out and get clogged eventually requiring a replacement. Keep in mind this high-quality item is made of dur...

This is a genuine OEM filter made by Hoover. It is a single pleated style filter designed for use all models of Hoover's FloorMate hard floor cleaners. It is located inside the recovery tank (dirty water tank) lid. This filter is washable. When suction is reduced, wash the filter. If suction still has not improved, replace the filter. Hoover recommends replacement every three to six months. One fi...

This is a genuine Hoover replacement filter. This cartridge-style filter is designed to fit inside the dirt cup. It is the main filter of the vacuum and is responsible for catching the majority of the debris. This is a HEPA (High Efficiency Particulate Air) filter, which is ideal for allergy and asthma sufferers. It is also known as a Type 201 filter.

This is a genuine OEM replacement part sourced from the original manufacturer. This inlet filter is a secondary filter designed to protect the motor from dust and dirt particles. It sits below the vacuum bag and is covered by the filter cover grill. This is a washable filter; rinse it in cold water and air dry for at least 24 hours.

This is an authentic OEM part designed for use in upright vacuums. This part fits onto the side of the machine and is accessed by opening the bag door. It is the final filter, which is the last air filter that cleans the air that is sent directly back into the room. This washable filter is designed to be reused until it is damaged or cannot be cleaned thoroughly anymore. It is sold separately.