THROTTLE TRIGGER 731-04970B-10

Remove the screws from the housing and separate them.
Make note how the spring is placed in the housing
Remove the spring and broken trigger and throttle cable
Install the new trigger and spring and throttle cable

Make sure when screwing the assembly back together that the wires and throttle cable do not bec ... Read more ome pinched where the assembly joins together.

Removed the trigger handle components. Removed broken trigger, replaced with new part but had problem with the trigger sticking and discovered it wasnÆt properly seated in the holder. DidnÆt need spring, but wasnÆt sure. Might need in the future.

Removed the torx head bolts
Split the handle apart, removed old trigger and spring.
Installed new parts.

I pulled apart the trigger housing, and easily replaced the trigger. The part was an exact match. And even got here earlier than expected.

1. Removed the plastic cover on the shaft which covered the on/off switch and the throttle.
2. Removed the broken piece and spring.
3. Thread the throttle cable through the hole in the end of the new throttle to allow correct pivoting while keeping the cable in place.
4. Placed the spring back in the middle of the thrott ... Read more le and centered the replacement piece over the fitting. Made sure the front of the spring was correctly placed in the right place to allow full movement of the throttle.
5. Sprayed some silicone lube on the center of the throttle piece to ensure smooth operation.
6. Replaced the screws which held on the cover.

Remove 6 screws split handle, removed broken part, put in new replaced screws. Works like new