Height screw was mashed into follower nut. The screw looked ok but the nut looked damaged.
You must remove the black faceplate to remove the screw and nut assembly
Replaced missing roll pin. Your website not only showed me the missing part, but prepared me for it\'s replacement through customer instruction. I had vise grips waiting. The Roll Pin needed to be squeezed down to fit within roller. Thank you E-Parts.
Did you find this story helpful?
Thank you for voting!
Broken pin roll, could not raise or lower table saw blade
Pin was too large, had to put in vise to make it a bit smaller which allowed it to go into the slot in the screw height assembly. Used a pair of needle nose pliers and a small hammer to tap into slot. Once the pin was inserted the blade was able to move up and down again. Be careful to not crack pin when putting it in vice.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10169769
Manufacturer Part Number: 330036-08
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
