I had recently replaces the two gears that let the handle raise/lower the blade. When comparing to the diagram, I noticed that one of the flat washers beneath the horizontal gear (the one connected to the threaded rod) was missing. Also during the previous repair, the two screws that hold the vertical gear in place were becoming stripped.
... Read more
I replaced the two screws (simple), and while the gears were disengaged, I raised the threaded rod above the mounting bracket and slipped the missing washer into place (no need to remove the gear). I then lubed all the moving parts and reassembled. The blade now raises/lowers as it did when the saw was new.
Read less
Did you find this story helpful?
Thank you for voting!
table saw height adjuster cog broke
MICHAEL from MOUNT SHASTA, California
0 of 1 peoplefound this instruction helpful.
Difficulty Level:
Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
