This item has been sourced from the original manufacturer to be used with scroll saws from Delta. The metal screw is commonly used to fasten the blade arms to the rear link. A flat-head screwdriver is needed to install this item. The special screw is priced as an individual item.
The old special screw was worn down greater than 1/16\" and the linkage bar also showed worn. Replacing both eliminated the looseness between the arms and the distance between the arm blade attachments. This I believe reduced the vibration as well.
1. Removed the side panel over the connecting link.
2. Removed the screws at each end of the connector link.
3. Installed the new parts with plenty of lube.
4. Reinstalled the side cover.
Did you find this story helpful?
Thank you for voting!
Great deal of play in the scroll saw arms and vibration
I removed the 4 screws covering the rear of the saws parallel arms. The arms are linked by a flat bar, held in place by the special screws. Remove two screws, remove old damaged link bar. Replace both bar and screws with new parts. Lubricate screws. In general, this would be a good time to lube the rest of the saw, per PDF instructio
... Read morens available on line.
Removed the worn link and screws from the upper and lower arm of my scroll saw, and replaced them with the new parts.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
