This is a genuine Dremel replacement part that has been sourced from the original manufacturer. The plastic brush cover is intended to be used with rotary tools from Dremel. The brush cover attaches to the motor housing and is used to provide access to the brushes. The brush cover is sold as a single part, please note two brush covers may be needed.
Troubleshooting
This part works with the following brands:
Dremel
Bosch
This part works with the following products:
Router
Hammer Drill
Multi-Tool
Part# 2610006518 replaces these:
2610006518,
★
Customer Part Reviews
?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(2 Reviews)
Click to filter by ratings:
5 stars
2
4 stars
0
3 stars
0
2 stars
0
1 star
0
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Great part
Part was right, and worked as expected
Brett - May 27, 2021
Verified Purchase
★★★★★
★★★★★
Repair parts
The parts was just what I needed. Thanks so much.
Larry - December 11, 2021
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Dremel used almost daily. Wore brushes out. When received new brushes and covers, disassembled Dremel and cleaned all to almost new, then installed brushes. Wore in brushes at 5000 RPM for about 5 minutes and Dremel runs like new.
Did you find this story helpful?
Thank you for voting!
Dremel could not maintain consistent speed setting
Replaced old brushes along with
Specifically
1. Remove power cord from wall
2. Unscrewed the two flathead screws securing the brushes inside
3. Pulled brushes from each side
4. Removed the 5 or 6 T15 TORX screws
5. Removed collar on drive shaft and hanging bracket from the rear
6. Took top off a
... Read morend notated which wires went where.
7. Removed the two brush holders and replaced with new ones
8. Reassembled and tested
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
