Sander Polisher Brackets and Flanges

This is a Genuine Manufacturer Sourced replacement part designed for use with Makita Belt Sander. It is Made out of Metal and it is Sold Individually. Due to constant contact, pressure and vibration this part should be inspected periodically and replaced if showing signs of wear to ensure optimum performance. When replacing Steel Plate it is advised to inspect the Cork Plate and replace it if it...

This replacement steel plate is a genuine Makita item, not an aftermarket imitation. It is specially designed for use with belt sanders. This assembly consists of a steel plate that helps to support the sandpaper and a cork backing to reduce the vibration. Over time this plate will wear out requiring replacement. Please note, this item is sold individually. The hardware to secure this steel plate ...

This steel plate is an authentic Makita replacement part. It is made specifically for the Makita 9924DB Belt Sander. This plate simply provides a durable surface for the sandpaper to push against during sanding. It should be replaced if it is worn or damaged. The installation for this part is straightforward and should only take a few minutes. A screwdriver is needed to remove and re-install the t...

This is a high quality replacement part designed for a Makita belt sander. It is an authentic item sourced directly from original equipment manufacturer. When replacing this steel plate it is advised to inspect the cork plate which is sold separately and replace it if shows signs of wear. Please note, this item is sold individually. To replace this steel plate you will need a screwdriver.

This is an Original replacement part used on certain Milwaukee Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Flange is to hold the Grinding Wheel to the Spindle Shaft. Flange designed to accommodate 7/8 In. hub depressed center wheel.

This authentic item is supplied by the original manufacturer for DeWALT random orbit sanders. It is the bottom half of the bearing retainer which is utilized to secure the armature bearing. The part is secured three screws which also attach the sanding pad. Note, the hardware is sold separately. It provides a high-quality replacement for a missing or a damaged part that was installed on a new unit...

This replacement steel plate is a high quality item that is specially designed for Makita belt sanders. Due to constant contact, pressure and vibration this part should be inspected periodically and replaced if showing signs of wear to ensure optimum performance. Please note one durable steel plate is included per order, to replace this part you will need a screwdriver.