Cub Cadet Pressure Washer Engines

This is an original Briggs & Stratton and Toro part for use in engines, generators, and lawn mowers. The exhaust valve goes next to the valve spring. This item is sold individually and is made of metal. A set of pliers may be needed during the replacement of this part. It will need to be replaced if it breaks.

The cylinder head attaches to the cylinder head gasket. It is an authentic replacement part directly sourced from the manufacturer for use in Briggs & Stratton engines and Toro lawn mowers. This item is available individually. A wrench might be needed during the installation process. This part may become broken and will need to be replaced.

This is an authentic OEM part for use with Craftsman Lawn Mowers. The engine breather vents air from the engine crankcase. The most common reason for replacing the breather is when the small engine runs poorly. This part is sold individually. Here is a list of tools that are needed to replace the breather a flat-head screwdriver, hammer, 7/16th-inch socket, 3/8th-inch socket or nut driver, Phillip...

It is made of metal and is sold individually. The intake valve goes next to the valve seal. A set of pliers may be required to replace this part. It will require replacing if it bends or breaks. This part is an OEM sourced directly from the manufacturer for use in engines, generators, and lawn mowers made by Briggs & Stratton and Toro.

This is an original replacement part sourced directly from the manufacturer. The timing gear is commonly found in engines and lawn mowers from Briggs & Stratton and Toro. This part is made of metal, and is secured to the crankshaft assembly. You may require pliers and a wrench when replacing this item. The timing gear is sold as an individual replacement part. Please note that the woodruff k...

(Standard) Used After Code Date 97011200 Used Before Code Date 09041700

This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. The special retainer is commonly used as spacing between the head of the valve and the valve spring. The retainer is available as an individual replacement part, please see model diagram for associative parts.