Hammer Drill Caps and Lids

This is an authentic Milwaukee replacement part manufactured for use with rotary hammers. The special dust cap is used to prevent debris from entering the sleeve. This dust cap is available as an individual replacement part, please see model diagram for associative parts.

This cord guard is a genuine Makita replacement part, and it is a direct replacement for a damaged or missing cord guard. Power tool cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point--right where the cord enters the tool. Over time cord guards will deteriorate and eventually require replacement. Keeping a strong cord guard on your tool ...

Genuine Makita replacement part, this item is sold individually. The purpose of the Brush Holder Cap is to retain the brush in the brush holder. This Brush Cap is used on all the Makita models listed below. It is removed by using a slotted screwdriver Do not press too hard when removing the cap they do have a tendency to break.

This is a genuine part which is supplied by the original equipment manufacturer for use with DeWALT and Black and Decker rotary hammers. The cap provides cushioning for the chuck. If the component is worn, damaged or missing, this will provide an identical replacement for the original cap that was installed on a new unit. Refer to the appropriate diagrams for your model to ensure the exact locatio...

• This cord guard is a genuine Makita replacement part and is sold individually. • Cord guards, also called cord protectors, are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. • This cord guard will fit cords for the tools listed un...

This dust cover is an original part from the Makita manufacturer. The plastic dust cover is made for use with the HK1810 Scraper. This feature fastens the tool retainer to the barrel cover. The dust cover is sold individually, and a wrench is required for the installation.

This battery cap provides secure coverage to protect battery terminals from debris and exposure.

This is an original Makita part. The holder cap is made of plastic and is used in saws and hammers. It attaches to the carbon brush and holds it in place. This cap is sold individually, however a screwdriver may be needed to replace this item if it becomes cracked or broken.