Makita Hammer Drill Caps and Lids

This cord guard is a genuine Makita replacement part, and it is a direct replacement for a damaged or missing cord guard. Power tool cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point--right where the cord enters the tool. Over time cord guards will deteriorate and eventually require replacement. Keeping a strong cord guard on your tool ...

Genuine Makita replacement part, this item is sold individually. The purpose of the Brush Holder Cap is to retain the brush in the brush holder. This Brush Cap is used on all the Makita models listed below. It is removed by using a slotted screwdriver Do not press too hard when removing the cap they do have a tendency to break.

• This cord guard is a genuine Makita replacement part and is sold individually. • Cord guards, also called cord protectors, are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. • This cord guard will fit cords for the tools listed un...

This dust cover is an original part from the Makita manufacturer. The plastic dust cover is made for use with the HK1810 Scraper. This feature fastens the tool retainer to the barrel cover. The dust cover is sold individually, and a wrench is required for the installation.

This is an original Makita part. The holder cap is made of plastic and is used in saws and hammers. It attaches to the carbon brush and holds it in place. This cap is sold individually, however a screwdriver may be needed to replace this item if it becomes cracked or broken.

This is an OEM part direct from the original manufacturer. The Makita cord guard 8 is made of durable rubber, and is compatible with various power tools. This item is often fastened into the housing and over the power cord, providing protection to the cord. The cord guard 8 is sold individually. A hex key and a screwdriver are helpful for the removal and repair. Please refer to the specific manual...

It is a genuine manufacturer-sourced which is specially designed for Makita power tools. Power cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point, right where the cord enters the tool. Unfortunately, over time the material will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality item is made ...

It is an authentic Makita item that is supplied by the original manufacturer for rotary hammers. The cap prevents dust from falling over the tool and a user when performing overhead drilling operations. Attach the dust cup to the bit as shown in the figure. The size of bits which the dust cup can be attached to is as follows. Unfortunately, over time the material will wear out and it may begin to ...