Drill Valves

This is a genuine OEM part. The Dynabrade tip valve is manufactured for use with orbital sanders, finishers and grinders. This metal and plastic valve often sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see specific manual for additional repair information. A pair of pliers, wrench and a screwdriver may be necessary for installation.

This is a genuine OEM sourced replacement anvil assembly. It is designed for Makita impact wrenches. This part is used to secure the bits. Anvil can wear out on both sides, either from inside the drill housing where the hammer mechanism strikes it or from the outside where it meets your bits. Please note, this metal anvil is sold individually. Performing this repair you should only need a screwdr...

This is a genuine OEM approved component which is specially designed for use with Dotco and Cleco power tools. It is an identical replacement for a missing or a faulty valve that was installed on a new unit. The valve sits inside of the cylinder and it helps to generate the power, please make sure to refer to the owners manual and the appropriate diagrams of your model for the correct location and...

This is an authentic OEM component from Dynabrade. The speed regulator assembly is compatible with many grinders and sanders. This metal and plastic item secures the valve stem in the housing, managing the airflow in the device. A wrench is often helpful in making the replacement.

The anvil fits between the nylon washer and the hammer. This item is available individually and is made out of metal. This is an original Makita part for use in impact drivers. It might require a screwdriver and an adjustable wrench to replace this part. It will require replacing if it becomes broken.