Drill Springs and Shock Absorbers

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is a Genuine OEM replacement part used on some Makita Power Tools. This is a Metal Spring and it is Sold Individually. Over time springs may loose its tension and may not function as intended. If this part is lost or damaged it must be replaced.

Genuine Makita replacement part, this item is sold individually. This part is used on the tools listed below, to contain all of the part that are attached to the front end of the tool. Such as the Chuck assemblies on the the Impact Drivers and the Spindle Assemblies on the Screwdrivers.

This is a Genuine OEM replacement part used on Makita drills and drivers. This is a metal spring and it is sold individually. Over time springs may lose its tension and may not function as intended. If this part is lost or damaged it must be replaced. To replace this spring a pair of pliers is needed.

This part is available as an individual replacement. The compression spring is made of metal and attaches to the switch lock. When replacing this item a screwdriver and a set of pliers may be needed. Over time this part may break or become lost and will need to be replaced. This item is an OEM sourced directly from the manufacturer for use in chop saws, cordless drills, and hazardous location scre...

It is a genuine item that is supplied by the original equipment manufacturer for use with Makita power tools. This is a high-quality replacement for a missing or a faulty leaf spring that was installed on a new unit. The purpose of this component is to apply tension on the speed change lever assembly allowing it to retract, please make sure to refer to the appropriate diagrams of your model for th...

This authentic manufacturer-supplied part is made for use with Makita shear wrenches. It is an identical replacement for a missing or a faulty hardware that was installed on a new unit. This is the spring that applies tension on the inner sleeve. Make sure to refer to the diagrams of your model for the exact location and the correct installation of this component. One durable metal compression spring is included.

This is an authentic OEM component from Makita. The compression spring 4 is compatible with a variety of power tools, and is sold individually. This metal spring provides the necessary tension for the tool motor, and is sold individually. For the the replacement, pliers and a screwdriver may be required.