Part Location Diagram of 647953-00 DeWALT GASKET, CAP
See part 12 in the diagram
( Grid squares measure 1x1 inch )

GASKET, CAP 647953-00

Manufactured by:
DeWALT
ERP Number:
ERP18985732
Part Number:
647953-00
Original Equipment Manufacturer ?
  Works with your model  FN250C!
$6.16
On Order
Minimum Quantity of 2 required

Easy 

15 - 30 mins 

(3 rated repairs) ?
  Works with your model   FN250C!

Product Description

?

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Porter Cable finishing nailers. This is a high-quality replacement for the gasket which is utilized to provide an air-tight seal for the main housing, over time it may wear out and begin to crack eventually requiring a replacement. Keep in mind this durable component is made of composite material and is sold individually.

Troubleshooting

This part works with the following brands:
  • Porter Cable
  • Craftsman
This part works with the following products:
  • Nailer
Part# 647953-00 replaces these:
647953-00, P647953-00,

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

15 - 30 mins 

(3 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

not working

andrew from QUARTZ HILL, California

1 person found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Parts Used:
647953-00, 647649-00-K
opened top of nailer, took apart the front, remover old broken plunger and replaced and installed new gasket
Did you find this story helpful?
Thank you for voting!

Nail driving pin broke and ruined the piston cylinder

Justin from Newark, Delaware

0 of 1 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
1. Removed the four bolts holding on the rear cap.
2. Removed internals.
3. Installed new internals with a light coating of oil.
4. Reinstalled rear cap with new gasket.
Did you find this story helpful?
Thank you for voting!

Leaking air

larry from dripping springs, Texas

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Parts Used:
647953-00
Removed the top cap
Remove the gasket and cleaned the areas of the gasket surface
Place the gasket on the housing
Place the top cap on, and screw it on.
Did you find this story helpful?
Thank you for voting!
  • 1

Model Cross Reference

This part works with the following models:
ERP Number: ERP18985732
Manufacturer Part Number: 647953-00
Brand Model Number Description
Craftsman CMPFN16K Nailer - 16ga Strght Fnsh Nlr
Porter Cable FN250C Nailer - 16 Ga. 2-1/2&#34 Finish Nailer Kit
Porter Cable FN250CR Nailer - Finish Nailer 16 Gauge