Removed the four torx screws holding the tool head to the body of the tool.
Pull on the tool head. If you are lucky, it will slide off the motor shaft.
More likely, the motor rotor will slide out of the tool with the tool head still attached since it is a press fit.
Use a heat gun to gently and slowly heat the tool head
... Read more to expand it slightly. Hold on to the motor armature being very careful to not damage it, and wiggle the tool head while pulling on it. It should pull free. Do not pry on anything! If the rotor slid out of the motor armature, you will have to take the housing apart so you can slide the rotor back in while holding the motor brushes out of the way.
The new motor head needs to be filled with grease. I just scooped the grease out of the old motor head and used that, adding a little new grease to it.
Now slide the new head back on to the body. It won\'t go on all the way because of the press fit bearing, but insert the 4 screws and alternately tighten them a little bit at a time and the new bearing will slide into place.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10163613
Manufacturer Part Number: 31508261020
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
