Heat Dam Gasket 900950001

I removed the blower tube, removed the plastic cover plat,(take pictures with your cell phone of the position of the throttle line) removed air filter, removed carburetor and heat dam along with gasket.Replace with new gaskets installed the new heat dam and gasket, replaced carburetor, replaced filter and cover installed blower tube. I th ... Read more ink the thing that took the most time was cleaning the unit do to the fuel that had leaked. Just make sure you get the throttle line back in the proper position. Works like new

After inspecting the carb. found the carb gasket was torn. Further inspection found that the heat dam was broken. Pulled the spark plug to find it somewhat fouled. Both carb bolts were damaged. After removing the intake filter box, removing the carb ***careful of the throttle bar on the left*** remove the carb gasket, remove the heat dam ... Read more via torx head screws. The heat dam gasket might need to be removed with a putty knife if it was saturated with fuel. Reinstall all the parts in order. Heat dam, gasket, Carb bolts in heat dam with threads outward, heat dam with two torx screws (alignment is tricky) and tighten the torx heads without breaking heat dam, carb gasket (long flat of gasket between engine and gas tank, install the carb with primer bulb on top and don\'t forget the throttle bar, install the filter box and tighten both nuts onto the bolts to ensure a tight fit of carb gasket. Very straight forward with just a bit of a tight area. Last item is the spark plug.Once together, prime and start.

Removed old part and replaced with new. All went easy like other projects using your parts and will do again on other projects.